Ready to Use
This strip light kit comes with everything you need. The lighting kit includes 5m/16.4ft lighting strip, controller box, power adapter plug, and 44-key remote. Ready for immediate use straight out the box. Just plug in and enjoy your lights.

Various Modes
Lighting strip comes with various options. Many colors and modes to choose from. You may select colors, which include, blue, green, red, purple. pink, yellow, etc. Other options include a quick, slow, auto, and flash option.

DIY Fitting
This lighting strip is very flexible and great for curving around bends. You may also use this product for fitting any shapes or angles you may need to fit your lighting purposes.

Waterproof
The waterproof rating of this strip light is IP65, so you can apply it outdoors without worrying weather condition. But please note that, the power adapter, controller box parts or any other connection joints are not waterproof, and do water repellent treatment with those parts when using outdoor.

Safe to Use
The product is low voltage (12V DC) and safe to touch. No concerns for your safety while using this product.

Parameters
Wattage (of Power Adapter): 36W
Input voltage (of Power Adapter): 100-240V AC
Input voltage (of Strip Light): 12V DC
Frequency (of Power Adapter): 50/60Hz
LED Type: 5050 SMD
LED Amount: 300 Units
Color: Red, green, blue
Length: 5m/16.4ft
Waterproof: IP65 (only for strip part, the power adapter and controller box parts are not)
Mercury Content: No

Package Includes:

1 x 16.4ft/5m 5050 RGB 300 leds waterproof RGB strip light
1 x 12V 3A Power Supply
1 x 44 key remote control
1 x AC cable
1 x button battery
1 x easy to read manual

Note:

1. We don't recommend you to connect strip to more than 5M in series (may not work well because of the voltage drop) and we don't sell higher wattage adapter.
2. Please be kindly informed that the total wattage of LED strip lights should not exceed the max wattage of this adaptor.

3. Please unroll the strip light before light it up.

Connecting power to RGB light strip with remote controller

Connecting two or more RGB light strips with only one power in parallel

Please be kindly informed that the total wattage of LED strip lights should not exceed the max wattage of this adaptor.

 
Fixing
It comes with self-adhesive backing for quick and easy installation.
Peel off the backing press onto most clean and flat finish surfaces.

Cutting
The cut points can be found every 3 LEDs usually with solder pads.
You can simply cut to the desired length using a pair of scissors along the cut point line.

Connecting
You can join/connect pieces of cut LED strip together using the solderless connector (not included so you will need to buy it extra please search 5000071)
1. Open the plastic housing up;
2. Slide both sides of the LED tape into the connector;
3. Clip-on the connector into place until you hear a snap.

Tips: please choose the right connector for your strip
Width: 10mm for 5050 tape 8mm for 3528 tape; 
Pin: 2-pin for single colour strip 4-pin for RGB strip